Wooden doors and windows should be noted that acceptance of what issues

Wooden doors and windows should be noted that acceptance of what issues

Hand percussion automatic doors doors and windows set side panels, if the issue of empty drums, it shows no mat Blockboard other grass-roots bottom plates, should be dismantled and redone.

1, appearance to appearance: The surface coating of wood windows and doors to be smooth, bright, no flow fall, bubbles, wrinkles and other defects, there is no corrosion points, dead sections, broken remnant; package sets of wood doors and windows and doors and windows should be wood fan, color coordination, color decorative panels and molding is not large, should be the same species.

2, door and window fans to the Founder, does not warpage, doors and windows just to fan into door frames, door frames and is consistent with: if doors and windows box fan with a large gap, mainly because not allowed to install or repair when the plane door and window frames is not perpendicular to the ground, remove the fan can be re-dig repair doors and windows; such as door frames are not vertical, plate gasket should be looking at the box straight.

3, hinge to automatic door position accurately, securely installed: If you did not hinge on the positive, will lead to sets of doors and windows do not coincide with the box fan, doors and windows switches is not smooth. Each hinge can be unscrewed a screw, then adjust the doors and windows fan and box fit, adjust and then repair and correct all the screws tightened. If the short hinge screws or nails on the screws look into, not tighten the screws, or screws ramp, fight fans will visit leading to doors and windows. Should be replaced right screws, the screws must be straight, screw should screw into the 1 / 3, and the rest to be screwed into it.

4, door open, lock to be smooth, locks in the doors and door frames to fit on two parts: the lock pretend to be inappropriate, not freely switch will cause the doors. Latch plate should be removed with a chisel repair the tongue groove, adjust the position of the mouth and then install the door latch. In addition, the direction of the door opening must meet the requirements.

5, doors and windows which have a set of base material: window cover made with MDF Blockboard or, should the first grass-roots grass-roots level keel plate to the window frame, and then nail the line; Door frame made of wood is preferred, the planing , planing straight, and then installed on the wall molding assembly is then covered with grass-roots board and veneer. Hand percussion doors and windows set side panels, if the issue of empty drums, it shows no mat Blockboard other grass-roots bottom plates, should be dismantled and redone.